This project has been boxed up and sitting under a table for probably 10 years now. I'm finally getting around to it. All I needed to do was replace the neck volume pot. That was the easy part. The challenge is getting it all back together with such limited access. Sure wish it had F holes! ha ha. As far as I could figure the only real option is to fish the pots and output jack through the body with wires. It wasn't easy but I got it all done and I was feeling pretty good about myself... until I went to pull the last one through. Of course, it would not line up. I tried and tried. Apparently, I did not leave enough slack when I soldered the grounding wires to all of the pots.
Has anyone here been through this before?
Has anyone here been through this before?