Just curious if this is normal/acceptable?
Long story short, I had a set of Kluson's from a 2018 USA Les Paul Tribute, and recently came into a 2019 USA Standard body. I went to install the tuners into the new 2019 thinking they're likely the same but they are a bit loose in the hole. I measured and the tuners are 10 mm but the holes in the Standard are 10.25 mm. Once I snug everything up they don't move, but I just didn't know if they were suppose to be snug in there before the screws were tightened or if a little play was alright?
Thanks
Long story short, I had a set of Kluson's from a 2018 USA Les Paul Tribute, and recently came into a 2019 USA Standard body. I went to install the tuners into the new 2019 thinking they're likely the same but they are a bit loose in the hole. I measured and the tuners are 10 mm but the holes in the Standard are 10.25 mm. Once I snug everything up they don't move, but I just didn't know if they were suppose to be snug in there before the screws were tightened or if a little play was alright?
Thanks