PTBeezer
New member
- Joined
- Feb 16, 2020
- Messages
- 6
In prepping for a complete electronics rebuild on a 1980 LPC, I am curious to know if anyone can advise where the stock bridge ground wire ties in to the ground loop. In the control cavity? If so, its not obvious. I have read that people have found this coming into the control cavity nearest to the neck volume pot (via a very small gauge wire) but I see nothing. No drilled holes and no small gauge wire.
Could it be tied to the bridge pickup ground within the bridge cavity and then fed into the control cavity via the switch wire bundle?
Thanks
Could it be tied to the bridge pickup ground within the bridge cavity and then fed into the control cavity via the switch wire bundle?
Thanks