Ztonemonster
New member
- Joined
- Oct 5, 2018
- Messages
- 6
So I just got rid of the circuit board and such and rewired my 2019 LP Classic with 50's wiring scheme, along with custom-wound modern PAF's from Lindy Fralin.
I used CTS 500k pots. On only my neck volume pot, I'm getting a strange sort of "false stop" between like 9.5 and 10. It stops as if it's all the way to 10, but if you twist just a bit harder, it'll go just a tad further. The biggest issue is that my sound is somewhat thin as you roll from zero to about 9-.5 (when it stops). Then, at that last little twist my sound get very full.
Is this simply a bad pot? Could it be something else? Has anyone else ever had a pot do this?
Thanks in advance for any advice you can offer this newbie.
I used CTS 500k pots. On only my neck volume pot, I'm getting a strange sort of "false stop" between like 9.5 and 10. It stops as if it's all the way to 10, but if you twist just a bit harder, it'll go just a tad further. The biggest issue is that my sound is somewhat thin as you roll from zero to about 9-.5 (when it stops). Then, at that last little twist my sound get very full.
Is this simply a bad pot? Could it be something else? Has anyone else ever had a pot do this?
Thanks in advance for any advice you can offer this newbie.