The Fender Forum
NEW! LPF Facebook Page
LilyPix
Merchandise & Donations
NEW! Burst Serial Log Home Page
LPF Homesite
Page 1 of 283 123451151101 ... LastLast
Threads 1 to 40 of 11311

Forum: Les Paul Tech Area

We are very pleased to have two Moderators of this Forum from Dave's Guitar Shop!

Phil Kirst was born and raised in Milwaukee WI. He has been playing music from a very early age but picked up guitar 11 years ago. After finishing high school Phil went straight to the guitar repair/building program in Red Wing MN and completed two years of training there. Directly after graduation he was offered a job as a repair tech at Dave’s Guitar Shop, where he’s been for 4 years. He has played and worked on more guitars than a lot of people get to see in their lifetime. Phil really digs old Les Paul Specials and Juniors from the 50s and anything finished in Inverness Green or Pelham Blue. He lusts over the ’56 factory black Les Paul Standard that is in Dave Roger’s personal collection.

Carl Meine attended Redwing Guitar School and has been a full time guitar tech at Dave’s Guitar Shop for 11 years. Carl, along with along with Phil Kirst and Nate Marcy, run the guitar repairs/restoration department at Dave’s Guitar Shop. They do a large amount of restoration work and repairs on every imaginable type of guitar out there. Because of the high volume, Carl has set up and repaired thousands of guitars and is intimately acquainted with all the major brands and in particular, Gibsons, Fenders and Martins. He has spent countless hours discussing the minutia of Les Pauls and other popular models and looks forward to using his knowledge to help out with any questions.

  1. Need advice on my 17 LP Classic

    Started by Thartman06, Today 01:46 PM
    • Replies: 2
    • Views: 25
    Today, 03:25 PM Go to last post
  2. Out of phase: flip the bridge magnet?

    Started by StSpider, 06-09-18 04:28 AM
    • Replies: 2
    • Views: 173
    06-15-18, 09:46 PM Go to last post
  3. Neutering the Neutrik Locking Jack

    Started by Bluebeard, 07-17-11 12:39 PM
    • Replies: 7
    • Views: 596
    06-15-18, 05:36 PM Go to last post
  4. Can anybody help with these pot posts?

    Started by dealoftheweek, 06-12-18 01:31 AM
    confused, les paul, wiring
    • Replies: 1
    • Views: 99
    06-12-18, 06:55 AM Go to last post
  5. Unusual Part Request..Help

    Started by TM1, 09-01-17 11:05 PM
    • Replies: 9
    • Views: 603
    06-08-18, 05:17 PM Go to last post
  6. Epiphone Upgrades

    Started by ChrisP, 05-29-18 01:06 PM
    • Replies: 9
    • Views: 224
    06-05-18, 01:15 PM Go to last post
  7. String rattling in tailpiece

    Started by Luca79, 06-04-18 02:24 PM
    • Replies: 5
    • Views: 110
    06-04-18, 04:14 PM Go to last post
  8. ABR Saddle notching on an ES-335

    Started by Dave71, 04-03-18 02:17 PM
    • Replies: 7
    • Views: 338
    06-04-18, 07:44 AM Go to last post
  9. Les Paul custom 1974 replacement neck

    Started by MasterT, 01-02-18 11:10 AM
    • Replies: 13
    • Views: 565
    05-29-18, 11:38 AM Go to last post
  10. I was silly, poor nitro touch up.

    Started by Morlock, 05-22-18 05:07 AM
    • Replies: 13
    • Views: 423
    05-27-18, 11:24 PM Go to last post
  11. Rubber Washers

    Started by jalevinemd, 05-20-18 11:02 AM
    • Replies: 9
    • Views: 300
    05-27-18, 06:33 AM Go to last post
  12. Rick aka Dr. Vintage contact...

    Started by garywright, 05-13-18 10:07 AM
    • Replies: 1
    • Views: 225
    05-26-18, 04:06 PM Go to last post
  13. Lets Talk Soldering Stations

    Started by Pellman73, 04-21-18 03:44 PM
    • Replies: 18
    • Views: 419
    05-25-18, 07:31 PM Go to last post
  14. Are 1/2” pup rings really 1/2”?

    Started by Zowenso, 05-24-18 08:13 PM
    • Replies: 0
    • Views: 83
    05-24-18, 08:13 PM Go to last post
  15. Yet another pickup question (sorry!)

    Started by Strumming Fool, 05-22-18 05:29 PM
    bright, lead, opinions, pickups, tone
    • Replies: 4
    • Views: 116
    05-24-18, 07:25 AM Go to last post
  16. Straight necks = better?

    Started by jesone, 03-16-16 06:50 AM
    • Replies: 21
    • Views: 4,751
    05-24-18, 02:04 AM Go to last post
  17. Magnet movement in P90

    Started by springhead, 05-19-18 11:41 AM
    • Replies: 1
    • Views: 79
    05-20-18, 04:30 AM Go to last post
  18. Epiphone Slash Snakepit Les Paul Repair

    Started by MelvinZ, 05-17-18 09:22 PM
    dents, epiphone les paul, repair, slash, snakepit
    • Replies: 2
    • Views: 124
    05-18-18, 08:16 AM Go to last post
  19. LP. Stop bar up or down on the high "E" side?

    Started by Gibby58, 05-17-18 10:36 AM
    • Replies: 3
    • Views: 117
    05-17-18, 12:55 PM Go to last post
  20. Help with Gibson Burstbucker 1 & 3 pickups

    Started by El Gringo, 05-08-18 10:32 AM
    • Replies: 3
    • Views: 187
    05-16-18, 05:26 AM Go to last post
  21. Lifted Inlay

    Started by guitplayer, 04-15-18 10:37 AM
    • Replies: 5
    • Views: 368
    05-15-18, 11:43 AM Go to last post
  22. 2016 Studio faded goes out of tune sharp.

    Started by AlbanyCO, 04-18-18 05:47 PM
    • Replies: 2
    • Views: 171
    05-11-18, 10:27 AM Go to last post
  23. ABR Comparasions

    Started by fender69, 11-24-15 12:37 PM
    • Replies: 31
    • Views: 8,844
    05-09-18, 09:00 PM Go to last post
  24. bending buzz

    Started by freshmoe, 05-09-18 01:29 PM
    buzz, fret, lespaul, setup
    • Replies: 2
    • Views: 118
    05-09-18, 03:13 PM Go to last post
  25. Pickguard screwless

    Started by Alart, 03-09-18 05:07 AM
    • Replies: 3
    • Views: 317
    05-06-18, 10:19 PM Go to last post
  26. Stewmac Touch-up Markers for Binding

    Started by jshape, 05-04-18 11:02 PM
    • Replies: 5
    • Views: 197
    05-05-18, 12:48 PM Go to last post
  27. Stringing along

    Started by Xpensive Wino, 05-03-18 03:06 PM
    • Replies: 0
    • Views: 207
    05-03-18, 03:06 PM Go to last post
  28. Optimizing the Callaham ABR-1

    Started by Xpensive Wino, 04-27-18 08:06 PM
    • Replies: 6
    • Views: 421
    04-29-18, 08:13 PM Go to last post
  29. 2015 Trad Pro III pick up question

    Started by lawdog454, 04-28-18 07:15 PM
    • Replies: 0
    • Views: 68
    04-28-18, 07:15 PM Go to last post
  30. Saddle adjustment screw question....

    Started by NewStrings, 04-11-18 05:31 PM
    • Replies: 8
    • Views: 338
    04-24-18, 05:11 PM Go to last post
  31. Working with Nylon 6/6

    Started by MeHereNow, 04-11-18 05:58 AM
    • Replies: 5
    • Views: 353
    04-22-18, 05:52 PM Go to last post
  32. Les paul PUP height screws

    Started by Pellman73, 04-19-18 05:14 PM
    • Replies: 8
    • Views: 211
    04-20-18, 05:29 PM Go to last post
  33. Explorer Wiring ?

    Started by gmann, 04-18-18 07:07 PM
    • Replies: 0
    • Views: 79
    04-18-18, 07:07 PM Go to last post

Page 1 of 283 123451151101 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


Scroll Down And Click On All Of Our Sponsors' Logos For Their Websites!