jamesrivard
New member
- Joined
- Jun 16, 2017
- Messages
- 6
Hi everyone, I'm new to the Forum and the new owner of 4 used xti 4000 amps. I am running all 4 amps in bridge mode, each amp runs 2 each 8 ohm speakers wired in parallel to give me a 4 ohm load. So 2 amps are fed with a dedicated 120 volt 30 amp circuit and the same for the other two amps, so whats happening when I play the amps is the display lighting on each amp starts flickering when I get the volume up hi, not clipping though. So my question is is this normal?
Thanks
I didn't find the right solution from the internet.
References: http://www.crownaudio.com/forums/index.php?/topic/5227-xti-4000-flickering-panel-lights/
Motion Design Video Examples
Thanks
I didn't find the right solution from the internet.
References: http://www.crownaudio.com/forums/index.php?/topic/5227-xti-4000-flickering-panel-lights/
Motion Design Video Examples